Connect a Scanner

Connecting iPhone to GPR+ Scanner
-
With the scanner OFF press and hold the button on the GPR+ scanner.
-
You will see Reset Bluetooth Pairing? on the screen. Keep holding the button while the scanner counts down.
-
Hold until it says Pairing Reset.
-
Go to settings on your phone.
-
Go to Bluetooth.
-
Scroll down to other devices (the scanner must be on when you are doing this).
-
You will see GPR+… select this.
-
If it asks for a PIN enter 1234 then select Pair from the top right of the screen.
-
Now go to the EquiTrace App.
-
On the Home page you should see a green bar saying Connected.
-
To connect to another device leave the scanner to power OFF (don’t use for 90 seconds) then repeat the steps above
Connecting Android Phone to GPR+ Scanner
-
Switch the scanner on by pressing the button BRIEFLY once.
-
The scanner screen will say Ready and the Bluetooth symbol will be flashing without a letter M next to it (if there is an M go to the instructions for scanner previously connected to an iPhone or iPad). The M stands for master mode, the symbol can look more like an Hdue to the display.
-
Go to settings on your phone.
-
Go to Bluetooth, this can sometimes be found under Connections.
-
Press on Bluetooth.
-
Make sure the scanner is turned on and look for it under Available devices.
-
You will see GPR+… select this.
-
If it asks for a PIN enter 1234 then select Pair from the top right of the screen.
-
Now go to the EquiTrace App.
-
You should see a menu with Select a device. Select the scanner you just paired.
-
You should now see a green bar on the home page that says Connected.
Connecting Android phone to GPR+ Scanner, After it has been Connected to an iPhone or iPad
-
Start with the scanner OFF. Press and hold the button on the GPR+ scanner.
-
You will see Reset Bluetooth Pairing? on the screen. Keep holding the button while the scanner counts down.
-
Hold until it says Pairing Reset.
-
Then follow the normal steps as described above.